How to Polish the car Lighthouses

Do the eyes of your vehicle are tired ? It’s time to polish the headlights and leave as new.

Polishing techniques Auto Lighthouses

To always be greater driving safety is essential to polish the headlights of the car and ensure proper illumination of all our ways. In addition, this task will make it look better, smarter, and maintain the resale value of your vehicle rather high.

AutoLearn easy ways to polish the headlights of the car like a pro, using what you probably already have at home.

Plastics headlight polishing ingredients

If the coverage of the headlights of your car is plastic, you must learn to polish and leave as new with simple but effective actions. To achieve this, you will need various elements, depending on the level of harm they have suffered lights. Get the following:

– Dish washing Detergent
– Water and bucket
– A microfiber cloth or other soft
– low contact adhesive tape to protect the body
– hard foam block (or a firm sponge)
– Sandpaper 500 of 1000 and 2000 grit, water / wet
– Polishing Paste for Plastic or headlights
– Alcohol gel
– Sealer for Plastic headlights

Working of a beacon at a time, both the front, rear, and also the upper and lower fog. Depending on the state you are, run these steps in order to be recovering the damage they have suffered logistical lights.

Steps to polish the headlights

Covers the body around each headlamp with masking tape (painter). Wash the plastic with water and liquid dish detergent, using a soft sponge. This will remove surface dirt and fatty deposits, among others. Dry well.

Wrap a stiff sponge (or block) with sandpaper 500 grit water. Review the surface of the lighthouse in horizontal movements, in one direction, never in circular movements or with too much pressure. Do it until the plastic headlight car look dull and uneven, and soft. Then clean with a microfiber cloth, going over areas that are not whitish, opaque and soft. When you’re happy, just clean with a cloth dampened with clean water.

The next step for polishing the headlights of the car is wet again the plastic with water to which you’ve added a few drops of liquid dish detergent, and this time, pass sandpaper water (and wet) of 1000 grains, wrapped in around the rigid sponge to even pressure again and no horizontal circular motions, and making sure the lighthouse and sandpaper are always wet. Rinse with clean water, dried to perfection, and repeat with sandpaper 2000 grit.

Then apply on dry the plastic headlight polishing paste, and distributed over the entire surface with a cloth or microfiber cloth. Apply a generous layer. Already covered, go to polish with the microfiber cloth in horizontal movements, as with sandpaper. Do it as long as possible, because the more Pula, will work better.

Rinse with water and washing up liquid, clarifying later. Dry well and alcohol gel applied with a soft cloth. Put sealant for plastic headlamps, and reviews over with a dry, soft cloth.

Finally, remove the tape, and repeat all the steps in the following plastic headlights polishing your car to perfection.

How to polish the headlights with toothpaste

A fairly easy way to polish the headlights of the car is to use a sensational ingredient toothpaste. To achieve this, works a lighthouse while protecting the outline with masking tape. Apply an amount of toothpaste (toothpaste, best if it is white, not gel) and, using a soft damp cloth, well, distribute it across the surface.

Rub all over your car lighthouse in small, horizontal and vertical circular motion. Apply more toothpaste as needed, and keep damp, clean cloth, rinsing many times as necessary. After at least 10 minutes, rinse with a clean cloth and water, and analyzed the results to see if you need to repeat the procedure, or if you can and go to the other glass.

It will take some time to polish the headlights, but it’s worth seeing the result, bright and neat, as it should be.

Leave a Reply

Your email address will not be published. Required fields are marked *